FEGA FORUM
Responses to Topic Postings
FEGA Home Page
Back to the main list of topics.

To the bottom of the response list.
About heavy-duty turntable base GRS...
I have a question about. This base is normally used with GRS Low profile vise. Could I use this base with GRS standard block? Are there any problems? I like standard block more than low profile vise.
Many thanks.

Posted by Patxi Apellaniz  at 11/24/2006 4:26:48 PM.
Patxi
I use one that I made similar to the GRS turntable and I use the standard block no problems.Hope this helps Dave

Posted by Dave London  at 11/24/2006 9:37:26 PM.
Patxi,
I've been using the GRS turntable for several months with the standard block and it works great. The low profile block was developed, I believe, so that the microscope eyepiece height would not be too uncomfortable when the turntable/block combination was mounted on the GRS shelf style bench mount system. This mount has only limited height adjustments, whereas you can mount the turntable at your best height with an adjustable floor pedestal and the height of the block is irrevalent.

Mark

Posted by Mark Sedlak  at 11/24/2006 10:41:03 PM.
The low profile vice reduces the overall distance from the bottom of the base to the eyepieces a couple of inches. If you are very short bodied the turntable could be down on or even in between your knees. This is the circumstance where most low profile users find it worth their while. Otherwise I know of no significant difference except you give up a little mass with the low profile which is no good if you do double guns and like the mass.

Posted by Lee Griffiths  at 11/25/2006 8:26:50 AM.
Records 1 to 4 of 4
Click here to post a response.
You must be logged in to be able to post a response.
To the top of the response list.
Copyright 2005 by the Firearms Engravers Guild of America, all rights are reserved.
Privacy Policy - Terms of Use - Copyright Notice
Site Administration