FEGA FORUM
Responses to Topic Postings
FEGA Home Page
Back to the main list of topics.

To the bottom of the response list.
An engraved grill ornament for Sam Welch's Model A.
Posted for Sam Welch. Sam can tell you more - but this an amazing project. The ornament is of "German" silver and is about 4 inches high. It was made from a belt buckle blank.
Earlier posts show the shift lever to the car. And you thought a Winchester lever action had a lot of surface area!
Good work Sam!

Posted by Bill Gamradt  at 6/16/2006 11:46:46 PM.
Thank you for sharing some more of your amazing work, Sam.
Just outstanding!
Best regards, John.

Posted by John Barraclough  at 6/17/2006 2:00:41 PM.
Hi Sam

That's beautiful. So when does the engraving start on the bodywork !!!

Best regards
Andrew Biggs

Posted by Andrew Biggs  at 6/19/2006 5:39:49 PM.
Andrew, I am still looking for a large enough graver! Actually, there is a good bit of engraving on dash and engine parts and there are a lot of stainless carriage bolt heads that will be worked on also. Thanks for the comment. Regards...

Posted by Sam Welch  at 6/19/2006 6:57:14 PM.
Records 1 to 4 of 4
Click here to post a response.
You must be logged in to be able to post a response.
To the top of the response list.
Copyright 2005 by the Firearms Engravers Guild of America, all rights are reserved.
Privacy Policy - Terms of Use - Copyright Notice
Site Administration