| As a newcomer to hand engraving on metal, I have some questions. I have a background in wood engraving for printing and have done scrimshaw and etchings, again for printing. As I go through the classic books on engraving and after visiting many websites I can't figure out how the background behind much of the scrollwork are made so black. For example on Lindsay's site, he shows some fabulous knife engraving with gold inlays. The backgroung is a pure flat black and really makes the engraving jump out. I have tried the "Antique Black" chemicals from N-graver Co. These help, but are nowhere near the effect I see in the books etc. Even on photos of old firearms, the engraving shows up with crisp contrast to the metal. What am I missing? Any info would be welcome. |
Posted by Mark Sedlak at 10/27/2005 10:40:32 AM.
| hi mark .. i went thru the same thing that you are then i found that flat black enamel in the spray can works the best . spray some in a cap then take a q-tip and spread it over the entire engraving , before it dries wipe off the excess . and then sand the entire engraving with a very fine paper .. ron |
Posted by Ron Nott at 10/27/2005 12:45:05 PM.
| Thanks Ron. I thought about doing just what you suggested but was afraid that the paint would wear off too easily. But if it worked for you, I'm going to try it. Thanks again. Mark |
Posted by Mark Sedlak at 10/28/2005 5:01:16 PM.
| Mark Part of what you are noticing in these pictures is the work of a good photographer. He's letting the light reflect off the surface of the piece thus increasing the contrast. I use a combination of things to blackenin engraving. I do like the antique background black from Ngaver better then paint. Easier to apply and holds up well. However at times I find the contrast too harsh and like using oil based etching ink as it is more subtle for fine details as in animals |
Posted by Martin Rabeno at 10/29/2005 9:37:07 AM.
| Thanks Martin. I've seen oil based prnters ink mentioned before. Is it the same ink as a conventional print shop would use or is it the special type used for etchings? Where did you get your supply? Mark |
Posted by Mark Sedlak at 10/30/2005 1:49:32 PM.
Records 1 to 5 of 5